Vacuum forming sheet metal

Moderator: Mike Everman

Rescyou
Posts: 100
Joined: Mon Oct 06, 2003 3:45 am
Antipspambot question: 0
Location: Alberta Canada
Contact:

Helium

Post by Rescyou » Mon Mar 01, 2004 4:21 pm

Viv,

I think I have to majority of the Helium system but I haven't messed with the cryopump at all.

I've been just itching to dismantle the T-Mole-Pump to get at the rotors, but I think I'll just keep it complete for the moment.

For those that have never seen the rotors/stators on one of these, check these out:


http://www.ansys.com/industry/defense/s ... l_2001.htm

http://www.teco.com.tw/sbu/en_version/pro02.htm

s.
The mind of a man is the man himself.

sparks
Posts: 64
Joined: Mon Oct 27, 2003 3:34 am
Antipspambot question: 0
Location: Sweden

Post by sparks » Fri Mar 05, 2004 2:13 am

I really think you should keep your vacuumeq. the way it is.
It´s ridiculously difficult to get som good vacuumpumps etc. without spending alot of money, and if you one day gets into homebrew-lasers you will find them extremely useful.

Post Reply