Titanium

Moderator: Mike Everman

Post Reply
Pieter van Boven
Posts: 181
Joined: Sun Oct 05, 2003 2:54 pm
Antipspambot question: 0
Location: the Netherlands
Contact:

Titanium

Post by Pieter van Boven » Tue Apr 06, 2004 8:41 pm

Hi,

who has experience in milling or turning Titanium? I found out that there is a piece of rest material (round 200mm length 400mm) on stock at my work and pulsejet-parts was the first thing that came up in my mind (..again). To be onhoust, I always tought it would be lighter then it felt.
Is there anyone that worked with this material before?

Pieter.

Post Reply