cad software

Moderator: Mike Everman

Post Reply
haaken
Posts: 20
Joined: Thu Mar 11, 2004 4:25 pm

cad software

Post by haaken » Wed Mar 17, 2004 4:44 am

Does anyone on this forum got capabilities too open cad files?

Mike Everman
Posts: 4930
Joined: Fri Oct 31, 2003 7:25 am
Antipspambot question: 0
Location: santa barbara, CA
Contact:

Post by Mike Everman » Wed Mar 17, 2004 5:36 am

Yah, I can open any cad file you got. I can make a PDF of it and send it back if you want.
Mike
__________________________
Follow my technical science blog at: http://mikeeverman.com/
Get alerts for the above on twitter at: http://twitter.com/mikeeverman

Gary Robinson
Posts: 22
Joined: Thu Mar 18, 2004 2:15 am
Antipspambot question: 0
Location: Central west NSW, Australia.
Contact:

Post by Gary Robinson » Thu Mar 18, 2004 11:00 am

Very good Mike.
I was wondering if you or any other here has a copy of Plate N Sheet Development V5.2.
Its a half handy sort of program. I'm just not capable of utilising mine fully for the obvious reason.
"If it dont glow, it dont go."

Post Reply