Sculpt a work of art

Moderator: Mike Everman

Post Reply
Posts: 10824
Joined: Sat Oct 11, 2003 10:14 pm

Sculpt a work of art

Post by Mark » Fri Feb 06, 2004 5:48 am

Here's a big blob of stuff which might could be molded/plastered/glass reinforced into some sort of combustion device. ... gory=42912


Mike Everman
Posts: 4943
Joined: Fri Oct 31, 2003 7:25 am
Antipspambot question: 0
Location: santa barbara, CA

Post by Mike Everman » Fri Feb 06, 2004 6:41 am

That's a pregnant idea. I was thinking stainless steel wool in something like that. Refractory composites... hmmm... around a wax form with a plumbing pipe for a spine...

Oh yeah this setup popped really good, 8" of 3/4 copper pipe, still playing with how far the snorkel goes down, then how long the pipe is. Blew the hair drier at the pipe and got a wopwopwopwop after the initial report. The hole in the whipped cream can is 1", so the annular opening is 1/16" all around. Need to make a wire holder so the flows aren't so screwed up as in this setup.
MVC-655S.JPG (47.5 KiB) Viewed 2364 times
Follow my technical science blog at:
Get alerts for the above on twitter at:

Post Reply