Hi, i have a question for people with experience in homemade jetengines. how can i get the best performance in my chamber combustion ? my turbocharger is a : Garret inducer 49 mm.
thanks
AGG
chamber combustion performance
Moderator: Mike Everman
-
- Posts: 503
- Joined: Sat Jul 23, 2005 11:11 pm
- Antipspambot question: 0
- Location: Australia
Re: chamber combustion performance
Hi AGG
Make is as large as possible so that air velocities are low , crossectional area of the flametube to be at least 3 times the inducer area , your inducer has 1,885 sq mms , so the flametube needs 5657 sq mms or ~85mm dia if a single can type.
Cheers
John
Make is as large as possible so that air velocities are low , crossectional area of the flametube to be at least 3 times the inducer area , your inducer has 1,885 sq mms , so the flametube needs 5657 sq mms or ~85mm dia if a single can type.
Cheers
John
-
- Posts: 36
- Joined: Sun May 08, 2005 7:11 pm
- Antipspambot question: 0
- Location: mexico guadalajara
Re: chamber combustion performance
thank you very much is just that i wanted now let's working on my proyect. i will try upload photos during week.
Cheers
Andres
Cheers
Andres