Gluhareff intake stage separation
Moderator: Mike Everman
Gluhareff intake stage separation
in the Gluhareff pressure jet plans, the separate intake stages in the drawing are shown portruding into the intake stage below, however, no dimensions are shown of how much. Does anyone know this?
Quantify the world.
-
- Posts: 31
- Joined: Wed Mar 10, 2010 2:24 am
- Antipspambot question: 125
Re: Gluhareff intake stage separation
between the 1st and 2nd stages --extenion of the 1st stage into the 2nd stage is 1/4 of the leght of the 1st stage----the end of the 2nd stage "pipe" should extend into the "fluting" by 3/4ers its' length------eg if the fluting "R" of the third stage in were to = 1.0" the end of the second stage "pipe" would be exactly 1/4 of an inch above the "throat" of the third stage "intake"----- extending 3/4ers of an inch into the "flute" (in the round designs) email for any questions kylebear2000@hotmail.com -----roland2001 aka kevin
-
- Posts: 31
- Joined: Wed Mar 10, 2010 2:24 am
- Antipspambot question: 125
Re: Gluhareff intake stage separation
PS i can show you how to do an "inline" as opposed to an "L" if you wish kevin
Re: Gluhareff intake stage separation
In the picture Gluhareff intake, the separation stage is 0, but the thrust is very low 3.5 pounds. Add sound file for evaluation.
daab
daab
- Attachments
-
- PresureJet Sound 10s.rar
- (1.28 MiB) Downloaded 503 times