Gluhareff intake stage separation

Moderator: Mike Everman

Post Reply
metiz
Posts: 1575
Joined: Fri Apr 21, 2006 6:34 pm
Antipspambot question: 125
Location: Netherlands

Gluhareff intake stage separation

Post by metiz » Fri Dec 02, 2011 9:52 pm

in the Gluhareff pressure jet plans, the separate intake stages in the drawing are shown portruding into the intake stage below, however, no dimensions are shown of how much. Does anyone know this?
Attachments
Pressure Jet (Full Plans).JPG
Quantify the world.

roland2001
Posts: 31
Joined: Wed Mar 10, 2010 2:24 am
Antipspambot question: 125

Re: Gluhareff intake stage separation

Post by roland2001 » Tue Jan 17, 2012 12:18 am

between the 1st and 2nd stages --extenion of the 1st stage into the 2nd stage is 1/4 of the leght of the 1st stage----the end of the 2nd stage "pipe" should extend into the "fluting" by 3/4ers its' length------eg if the fluting "R" of the third stage in were to = 1.0" the end of the second stage "pipe" would be exactly 1/4 of an inch above the "throat" of the third stage "intake"----- extending 3/4ers of an inch into the "flute" (in the round designs) email for any questions kylebear2000@hotmail.com -----roland2001 aka kevin

roland2001
Posts: 31
Joined: Wed Mar 10, 2010 2:24 am
Antipspambot question: 125

Re: Gluhareff intake stage separation

Post by roland2001 » Tue Jan 17, 2012 12:20 am

PS i can show you how to do an "inline" as opposed to an "L" if you wish kevin

daab
Posts: 15
Joined: Wed Jun 30, 2010 11:16 pm
Antipspambot question: 125

Re: Gluhareff intake stage separation

Post by daab » Mon Jan 23, 2012 2:31 am

In the picture Gluhareff intake, the separation stage is 0, but the thrust is very low 3.5 pounds. Add sound file for evaluation.

daab
Attachments
PresureJet Sound 10s.rar
(1.28 MiB) Downloaded 490 times
IMG00178.jpg
My Gluhareff intake

Post Reply