Moderator: Mike Everman
4 posts • Page 1 of 1
in the Gluhareff pressure jet plans, the separate intake stages in the drawing are shown portruding into the intake stage below, however, no dimensions are shown of how much. Does anyone know this?
Quantify the world.
between the 1st and 2nd stages --extenion of the 1st stage into the 2nd stage is 1/4 of the leght of the 1st stage----the end of the 2nd stage "pipe" should extend into the "fluting" by 3/4ers its' length------eg if the fluting "R" of the third stage in were to = 1.0" the end of the second stage "pipe" would be exactly 1/4 of an inch above the "throat" of the third stage "intake"----- extending 3/4ers of an inch into the "flute" (in the round designs) email for any questions firstname.lastname@example.org -----roland2001 aka kevin