horned beast/status
Posted: Sun Oct 05, 2003 6:06 pm
Hi all:
I just thought it would be fun to be the first one to post something on the valveless PJ forum--since that's where my primary interest lies.
My pulsejet project is on hold, now probably for at least another week.
I've torn down the front-end, and I'm replacing the flat plate with much heavier material, to prevent deformation from heat and pressure.
Also, since the intake base tubes aren't welded into place yet, it would seem a good time to install a liquid fuel delivery system. So, I've designed and manufactured some components, but I'm waiting for the atomizing nozzles to arrive before I can finish and put the whole back together again.
All that plus a death in the family means considerable delay in the forward motion of this project. I'll provide updates as soon as progress resumes.
Bill H.
I just thought it would be fun to be the first one to post something on the valveless PJ forum--since that's where my primary interest lies.
My pulsejet project is on hold, now probably for at least another week.
I've torn down the front-end, and I'm replacing the flat plate with much heavier material, to prevent deformation from heat and pressure.
Also, since the intake base tubes aren't welded into place yet, it would seem a good time to install a liquid fuel delivery system. So, I've designed and manufactured some components, but I'm waiting for the atomizing nozzles to arrive before I can finish and put the whole back together again.
All that plus a death in the family means considerable delay in the forward motion of this project. I'll provide updates as soon as progress resumes.
Bill H.