competition
Moderator: Mike Everman
-
- Posts: 346
- Joined: Tue Dec 14, 2010 7:31 am
- Antipspambot question: 125
- Location: india
- Contact:
Re: competition
thank you joe,but i have a question here what should be the angle between the three intakes..hello metiz can you help me out with this(intake design)..
Re: competition
75 degrees works for me but it isn't set in stone. try anything between 75 and 120 degrees
*edit* didn't read correctly: if you have 3 intakes then go for 120 degree sepperation
*edit* didn't read correctly: if you have 3 intakes then go for 120 degree sepperation
Quantify the world.
-
- Posts: 346
- Joined: Tue Dec 14, 2010 7:31 am
- Antipspambot question: 125
- Location: india
- Contact:
Re: competition
take a look at the pic,have i done it correctly..And any idea how much thrust it will give..metiz wrote:75 degrees works for me but it isn't set in stone. try anything between 75 and 120 degrees
*edit* didn't read correctly: if you have 3 intakes then go for 120 degree sepperation
Re: competition
what is the angle of the intake, is the length measured from the centreline, is the length measured to the end of the flare or to the end of the intake, what is the flare length?
Quantify the world.
-
- Posts: 346
- Joined: Tue Dec 14, 2010 7:31 am
- Antipspambot question: 125
- Location: india
- Contact:
Re: competition
angle of the intake is 20 degree,length is measured from centreline..Yes length is measured to the end of the flare..flare length is 0.7cm..
Re: competition
FWIW I calculate the minimum intake length near 14cm. Of course my intakes are typically short, so take liberty, go longer and trim to a suitable length.
Re: competition
I realy don't like this style engine, it looks all wrong Anyway, your intakes look about right. Reduce them to 16.05cm
- Attachments
-
- engine.JPG
- (6.98 KiB) Downloaded 56 times
Quantify the world.
Re: competition
Its the new fugly stick.