2nd build video
Moderator: Mike Everman
Re: 2nd build video
Good job,
Looks like she locked in fairly well.
Looks like she locked in fairly well.
Re: 2nd build video
Thanks PJ! It took a little tweaking the injectors but once I got that close it fired right up. It was pretty gusty the other night and it almost sounded like it wanted to selfstart. This stuff is fun. I am ready to build bigger already. Checked the recording and it looks like 140hz at 100 decibals if I am reading the program right. Not sure. Using IAnalyzer Lite
-
- Posts: 5007
- Joined: Fri Oct 31, 2003 7:25 am
- Antipspambot question: 0
- Location: santa barbara, CA
- Contact:
Re: 2nd build video
Nice, be sure you do not breathe the galvanize fumes!
Mike Often wrong, never unsure.
__________________________
__________________________
Re: 2nd build video
Thanks Mike! I am having a blast with this stuff. Just got the fittings to remove my regulator and run some liquid through it. Going to cut the tail back to 9xD, cone to 6 and end of exhaust to 5 as per Pyro Joes example. Then it's on to a M40. Talked to my mechanic today and he's got a tube bender so I'm going to see if he's interested in doing a chinese.
Re: 2nd build video
I'm really not the guy to answer this question, I'm a newbie. Post this qustion to Mike or Joe. I haven't built a lockwood yet.
Re: 2nd build video
Who is Mike or Joe ? Im also a new to this forum
-
- Posts: 5007
- Joined: Fri Oct 31, 2003 7:25 am
- Antipspambot question: 0
- Location: santa barbara, CA
- Contact:
Re: 2nd build video
Offom, you are getting help for the same project in two other threads. Please don't start another. Thanks.
Mike Often wrong, never unsure.
__________________________
__________________________
Re: 2nd build video
Ok, I was trying to catch possible users attraction. Sorry for that, I be silenced now
Re: 2nd build video
I modified my current modle and spent about an hour last night trying to get it to sustain. It would not. Here again I didn't pay attention to exact measurments. My barrell is 2.25" ID and I figured 2". Duuuh! I can tell when I get this right this puppy is going to scream! Just got a Henrob torch so I can weld sheetmetal. Think I am going to start over from scratch. Will post vid when done.