hello, I have questions that I am not able to respond them to me,
somebody is able?
if I have lockwood that works well,
that it happens if I shorten the air intake to him?
if I diminish or increase diametro of entrance?
that it happens if I do greater camara?
that it happens if increase or I diminish diametro of the exit?
and if I shorten it?
as it changes this in valveless?
that it happens if lockwood works with little push and when increasing propano it stops that solution has?
I hope that somebody can resonder that.
now a small please aid.
today in my school they gave to a plate and tosay me to me:
- your you must make of this a motor designed by you.
since I do it?
by where beginning?
that calculos I use?
Francisco cooreman
lockwood proyect
Moderator: Mike Everman
-
- Posts: 226
- Joined: Tue Nov 30, 2004 1:06 pm
- Antipspambot question: 0
- Location: RIO CUARTO, CORDOBA, ARGENTINA
re: lockwood proyect
HELLO, THAT HAPPENS? THERE IS NOBODY IN THIS FORUM THAT CAN ANSWER TO ME? SURELY THAT IF.
THIS INFORMATION IS VERY UTIL FOR MY
THANKS
FRANCISCO COOREMAN
THIS INFORMATION IS VERY UTIL FOR MY
THANKS
FRANCISCO COOREMAN
re: lockwood proyect
Je ne parle pas l'espagnol, pourquoi tu ne parles pas l'anglais ?
-
- Posts: 226
- Joined: Tue Nov 30, 2004 1:06 pm
- Antipspambot question: 0
- Location: RIO CUARTO, CORDOBA, ARGENTINA
re: lockwood proyect
SINGLE I SPEAK SPANISH, I USE TRANSLATORS FOR THE INGLES.
FRANCISCO COOREMAN
FRANCISCO COOREMAN