PM sentdyna-fogger_46074 wrote: ↑Thu Apr 20, 2023 1:14 amAll the SS that was welded while I was there was done by Tig.
I don't know when the RedHead went OOP, but there were some old Tig machines we scrapped, and the Tigs they were using were 15+ years old, and we didn't scrap any gas welding stuff. So I suspect the RH was tigged also.
How quickly did those overseas reproduction RedHeads sell out? Do they pop up on ebay or have people held onto them? (I personally don't know)
That might give a clue to the market. Plus, sometimes anything that's new will sell. (that's something I have seen in the hobby realm)
Send me a private message and we can discuss getting this jig to you somehow?
You'll still have the hurdle of machining the aluminum inlet and other stuff, too.
Gerald Wiles
Moderator: Mike Everman
-
- Posts: 6
- Joined: Sat Apr 15, 2023 3:31 pm
- Antipspambot question: 125
Re: Gerald Wiles
-Mike
-
- Posts: 4986
- Joined: Fri Oct 31, 2003 7:25 am
- Antipspambot question: 0
- Location: santa barbara, CA
- Contact:
Re: Gerald Wiles
Wow, that post is why I keep this trove alive! Thanks, Dynafogger!
Mike Often wrong, never unsure.
__________________________
__________________________
-
- Posts: 12
- Joined: Tue Dec 13, 2022 2:29 am
- Antipspambot question: 125
Re: Gerald Wiles
You are quite welcome.
Wish all of it would've unfolded faster, while Jerry was still active on here. But we're not in control of it all.
So I'll just play the cards from here/now.
Wish all of it would've unfolded faster, while Jerry was still active on here. But we're not in control of it all.
So I'll just play the cards from here/now.