www.pulse-jets.com

That may be possible! The coil now is 50cm in length and when the engine stops runinng vaporized diesel is coming out of the nozzles fo around 10 sec´s! (quite a lot of white fog in the shop... hehe). I have a slightly bigger brass pipe here which I will turn into a bigger volume vaporizer! I´ll giv...

Hi folks, it´s quite a long time I have been around here but time did not permit me to build any pulsejets for a long time. Maybe the old forums members will remember me! But last week I got infected again by the noise virus and decided to put a small thermojet together! Now the project, I want this...

Thank you very much! I´ll take your advice and see how to atach the 4jaw chuck on my lathe, better safe then sorry.

Many Thank!

Could you explain how you got the measurement? Any straight formula for that?

Thanks, mag

Hey folks, just one question I can´t find a solution for in the web or in my books. I want to build a small crankshaft for a little engine on my lathe. The problem is, how thick hast the part to be which I have to put under one of the 3 jaws of the chuck. There should be a formula so I could find ou...

Merry Christmas and a Happy new Year to all of you here!

Greetings from Cold Germany, Mag

maybe try to make the spark gap a bit bigger on the spark plug, this helped me on my valveless engines, with the gap to small it wont ignite the propane.

Reichenberg wrote:

Mark wrote:Have you tried to start the "bazooka" yet? ha

Yes, but the "bazooka" does not run stably enough.

Thats what i thought, I would say the pipe is way too short for stable running. just add 10cm to the pipe and test again.

man, thats the nicest work i have ever seen! This project is realy a professionel work!

Please post some videos of the engine running!


Man, this Engine is realy nice!

Thanks for the Help Remko!

Stay tuned folks, building will start soon!

Hi folks, I just wanted to ask if someone knows if there are model plans available for the Fi 103 aka V1 or the Fi 103 Reichenberg as Im planning to build a flying model powered by a valved engine :D Dimensions of the Original V1 would help also, i have the length and the span already but how wide i...

Sure you can use them, they are cageless ceramic bearings and that is what you want.

I thought the GT12 is the smalles Garrett charger? With the 41mm Comp wheel?

as i did some research now i think the wheel is out of the turbocharger of an SMART 600ccm engine. I will see and buy a cheap one at ebay...

Hi, does anyone know which compressor wheel is used in the lambert Kolibri 32mm Turbine? Are there Plans or closeup pictures of the construction available?

Thanks and greetings, Mag

Danke für den Tip, habe dir Firma gefunden, werde mir dort Lager bestellen.