Search found 5 matches
- Mon Jul 11, 2005 12:24 am
- Forum: Valveless pulsejet forum
- Topic: lockwood dimensions?
- Replies: 12
- Views: 9594
re: lockwood dimensions?
well, i took the other engine and used the dimensions of it to scale down by 30%. now the dimensions are similar to the one u showed me actually. the one i'm building is just a bit bigger. i have the combustion chamber , intake, and the end of the tailpipe. i have to get the 180* bend thou....
- Fri Jul 08, 2005 10:50 pm
- Forum: Valveless pulsejet forum
- Topic: lockwood dimensions?
- Replies: 12
- Views: 9594
re: lockwood dimensions?
ok thanks.
i wasn't sure if the other engine would have that much thrust, but it's good that u caught me b4 i started making the engine. thanks a lot and i will meausre out the right dimensions to use for our application
jong-ki
i wasn't sure if the other engine would have that much thrust, but it's good that u caught me b4 i started making the engine. thanks a lot and i will meausre out the right dimensions to use for our application
jong-ki
- Fri Jul 08, 2005 7:10 am
- Forum: Valveless pulsejet forum
- Topic: lockwood dimensions?
- Replies: 12
- Views: 9594
re: valveless/motorjet?
hi again, well, my friends and i have decided to go with the conventional lockwood engine. i am using the engine below for references, but i believe it is not accurate because the Tl= 2500 mm and the Tm=92.3mm..... i don't get this because in the diagram it says Tm=162mm(and shouldn't the Tm be bigg...
- Wed Jul 06, 2005 9:53 pm
- Forum: Valveless pulsejet forum
- Topic: lockwood dimensions?
- Replies: 12
- Views: 9594
re: valveless/motorjet?
thanks for replying larry, no, i do not intend on going in the golf course too much with my golf cart. and i do not intend to have too much of a load factor. i am just wanting to build the jet engine around a platform... i just am available to golf carts a lot easier than i would be to a go-kart. i ...
- Wed Jul 06, 2005 7:28 am
- Forum: Valveless pulsejet forum
- Topic: lockwood dimensions?
- Replies: 12
- Views: 9594
lockwood dimensions?
hello, i am new to the forums, and i am wanting to build an engine, that would create a significant amount of thrust. My ultimate goal would to mount this engine on a golf cart(i live on a golf course bascically). My friends and i were thinking and they think a turbine would be too hard(which i agre...